FANUC: RS232 Communication Setting up your FANUC control for RS232 Communications. Large for the internal Fanuc memory. The program must adhere to this format for the Fanuc to take it into internal memory:% O1234 (Program description 1st digit is the letter 'o', not zero.

Hi all Just looking for a but of guidance with setting up my Lathe with a 6T Controller. I'm have a issue of the G50 cmd not holding the correct location after you do a manual jog or handle operation. After doing a bit of hunting i found a post in this forum 'Absolute cords reset in handle mode'.

I'm wanting to know if my lathe is set up for abs or inc programming by default. What parameter address do i look at to find the setting of this data bit and what to change it to to set it to abs mode.

I tryed to run a G90 in the midi but that put's it into cutting cycle mode not ABS mode Cheers Snow.

Have a Hitachi-Seiki 4NE-600 lathe that stops at alarm 401 (servo) during execution of program. I have three Fanuc manuals 1) Operators Manual (B-52244E/01) 2) Maintenance Manual (B-52245E/01) and 3rd) unknown, as front cover is missing along with pages 135-138,143-148 and last page is 332(not sure if there should be more). As these pages refer to alarm 401 and are torn from book, they are probably the right way to follow for repair. Question is, does anyone recognize manual, and can anyone supply replacement copies of pages missing?

I have attached copy of first page of manual in question and any hint on 401 error would be welcomed. John Bennett Ottawa,Canada. I have a Takisawa TX210D PRODUCTION lathe, fanuc 6t(a). The year model is 1980 and machine no. I got every thing to work as the lathe was out of commision four years.

Then playing around i accedently changed or deleted a parammeter and now no servo movement. No jog or manual pulse handle. Pdmworks keygen solidsquad 2017. The dro display the travel but servo do not move. Dro runs to 6.000 as set in par 78 and par 79 for both axes and then trip out velocity control circuit. Error alarm 411 and 421. I think i deleted or changed pc parammeters.

Can anyone please help or direct me to. The machine is 30 years old but somebody must still know the setup and pc parammeters on my machine.

Rtcw venom mod. Thank you Regards Daniel. Have a Hitachi-Seiki 4NE-600 lathe that stops at alarm 401 (servo) during execution of program.

I have three Fanuc manuals 1) Operators Manual (B-52244E/01) 2) Maintenance Manual (B-52245E/01) and 3rd) unknown, as front cover is missing along with pages 135-138,143-148 and last page is 332(not sure if there should be more). As these pages refer to alarm 401 and are torn from book, they are probably the right way to follow for repair. Question is, does anyone recognize manual, and can anyone supply replacement copies of pages missing? I have attached copy of first page of manual in question and any hint on 401 error would be welcomed. John Bennett Ottawa,Canada chek led in servo dive if is TGLS chek code or motor cabele. Hello i over in india doing a repair on a plasma cutter and they have a hitichi v50/55 mill with a late fanuc 6mb with 14 colour screen. When it boots you get something like filo ok then ram ok but nothing after this any idears or does any one have a late 6mb mainance manual with the 14inch fault finding section to it and graphic board testing.